Ynstallaasjegids foar it Roth QuickTemp Compact-systeem

Roth QuickTemp Compact System

Produkt Spesifikaasjes

• Ofmjittings: 61 sm x 61 sm x 40 sm
• Maximum load: 2mm per meter
• Gearstalling nedich

Planlæg hvordan Compact pladerne skal udlægges. OBS.

  Always read the full documentation

Stofsûgje de ûnderflier.

Split the turn plate and lay it first.

De groeven tusken de platen moatte op ien line wêze.

Cut plates from the back, remove any burrs.

Brûk oerdrachtplaten foar oanfierpipen/om gatten te foljen.

Vacuum before installation of pipes.

Ynstallearje de piip strak/tichtby de binnenste sirkel yn beurten.

Ynstallearje pipen en fiere druktests út.

Vacuum before installation of flooring underlayment

Flooring underlayment. Avoid overlapping.Lay wood floor at a 90° angle to pipes.

• ROTH DANMARK A/S · Tlf. +45 47 38 01 21 ·
  • E-post: service@roth-danmark.dk · roth-danmark.dk
• ROTH SVERIGE AB · Tel. +46 40 53 40 90 ·
  • E-post: service@roth-sverige.se · roth-sverige.se
• ROTH NORGE AS · Tel. +47 67 57 54 00 ·
  • E-post: service@roth-norge.no · roth-norge.no
• ROTH FINLAND OY · Puh. +358 (0)19 440 330 ·
  • S-post: service@roth-finland.fi · roth-finland.fi
• ROTH UK Ltd. · Phone +44 (0) 1905 453424 ·
  • E-post: enquiries@roth-uk.com · roth-uk.com

Ynstallaasje Stappen

1. Place component A on a flat surface with dimensions 61 cm x 61 cm.
2. Attach component B to component A using the provided screws (X mm).
3. Ensure that the maximum load of 2mm per meter is not exceeded.
4. Connect component C to the assembly following the designated markings.
5. Secure all components in place as per the assembly diagram.
6. Continue adding components in the specified order until the structure is complete.
7. Check for stability and make adjustments if necessary.
8. Your product is now ready for use!

FAQs